Publicidad
Idiomas disponibles
Idiomas disponibles
9. Troubleshooting
Switching on the machine briefly reduces the
voltage. Unfavourable mains power conditions may
have a detrimental effect on other machines. Power
impedances less than 0.3 ohm should not cause
malfunctions.
10. Accessories
Use only genuine Metabo accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
For the complete range of accessories, see
www.metabo.com or the main catalogue.
11. Repairs
Repairs to electrical tools must only be carried
out by qualified electricians!
A defective mains cable must be replaced only with
a special, original mains cable from Metabo
available from the Metabo service.
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
12. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
13. Technical Specifications
Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
P
= Rated input
1
P
= Power output
2
n
= No-load speed
0
n
= On-load speed 230 V
1
n
= On-load speed 110 V
2
T
= maximum depth of cut
max
T
= max. depth of cut (90°)
90°
T
= max. depth of cut (45°)
45°
A
= adjustable angular cut angle
Ø
= saw blade diameter
d
= saw blade drill diameter
a
= max. base body thickness of the saw
blade
b
= cutting width of the saw blade
m
= weight
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three
directions):
a
= Vibration emission value
h, D
(Sawing chip board)
K
= Uncertainty (vibration)
h,D
Typical A-effective perceived sound levels:
L
= Sound-pressure level
pa
L
= Acoustic power level
WA
K
, K
= Uncertainty
pA
WA
The noise level can exceed 80 dB(A) during
operation.
Wear ear protectors!
ENGLISH en
9
Publicidad
