Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
CAUSE
2. Excessive dirt on
Incorrect duct
glass
Inappropriate fuel
Overly closed registers
3. Glass bleaching or
Excessive
colour fading of the
excessive heat
plate
chamber
4. Poor heating
Inappropriate fuel
Insufficient load
Combustion control registers in the
wrong position
5. Venting smoke and /
First lighting
or
gases
from
the
front, bad smell
Flammable or combustible items in the
enclosure or surrounding walls of the
equipment
Crack in the combustion chamber of the
equipment
6. Excessive draft
Incorrect duct
Combustion control registers in the
wrong position
7. Poor draft
Incorrect duct
Duct dirtiness
7. CE INFORMATION
The CE label is located on the appliance.
This label contains technical data and OF number. (This number can also be found in the guarantee).
THIS NUMBER IS ESSENTIALFOR ORDERING SPARE PARTS.
CAUTION:
-
All tests are carried out in observance of Regulations
UNE-EN13240:2002-A2:2005-AC: 2006-A2:2005/AC: 2007 "Stoves that use solid fuels – Requirements and
test methods".
-
The review of the equipment, the installation and ducts must be carried out by a professional.
-
In case of doubt regarding the described herein, please contact your Rocal dealer.
-
FAILURE TO COMPLY WITH THE OBLIGATIONS DESCRIBED HEREIN OR IMPROPER HANDLING OF THE
EQUIPMENT SHALL EXONERATE THE MANUFACTURER OF ANY LIABILITY.
SOLUTION
Revise section on insufficient flue (below).
Use recommended fuel
Adjust registers
temperature
caused
by
Check the fuel load avoiding overheating
in the combustion
Adjust registers
Use recommended fuel
Adding fuel
Adjust registers
Wait for the polymerization process of the paint to finish; this can take from one
to several lightings.
Review of insulating materials such as fiberglass, fireproof wood or any
inflammable elements and replace them.
Check for tightness and if you discover a crack, please contact your dealer.
Duct servicing
- Excessive length
- Check Depression
- Incorrect diameter
- Check door gasket
Open the primary and secondary register following the steps outlined in the
manual. Should this not have an effect, check that the flue duct is clean; if it is
not clean, contact a professional to clean this. If the problem persists contact
your dealer.
Pag. 11
Publicidad
