Switching on and off (fig. F)
• To switch the appliance on, slide the on/off switch
(4) forward to position I.
• To switch the appliance off, slide the on/off switch
(4) back to position 0.
Optimizing the suction force
Rotating the bowl (fig. A) agitates the filter to remove
dirt; however, in order to keep the suction force
optimized, the dust container and filters must be
cleaned regularly.
Cleaning the dust container and filters
(fig. G - K)
There are two methods of cleaning the bowl,
a quick empty method and a thorough clean
method.
For the quick empty method use the following
instructions.
• Press the release latch (6) and open the
container door (5) (fig. G).
• Empty the dust container (14).
• Close the dust container door (5). Make sure that the
release latch (6) clicks into place.
For the thorough clean method use the following
instructions.
• The dust container (14) is attached to the body
of the appliance. To remove the dust container,
press the dust container release button (2) and
rotate the dust container (14) counterclockwise
and carefully slide the dust container clear of the
appliance.
• Remove the main filter (16).
• Brush any loose dust off the filter (15).
• To remove the pre-filter, rotate the pre-filter
counterclockwise and carefully slide it clear of the
dust container.
• The dust container can be cleaned. Wipe with
a damp cloth or rinse with warm soapy water and
allow to dry.
• The filters are re-usable and should be clea ned
regularly. Rinse with warm
soapy water and allow to dry.
• Install the pre- filter into the dust container (14)
rotating it clockwise until it locks into place.
• Install the main filter into the
pre-filter.
• Install the dust container (14) to the appliance,
rotate it clockwise until it locks
into place.
WARNING:
Hazard: Never use the appliance without the filters.
Optimum dust collection will only be achieved with clean
filters.
CAUTION:
when dust container is removed.
Projectile/Respiratory
Do not turn appliance on
6
F
G
H
I