J
Replacing the filters
The filters should be replaced every
6 to 9 months and whenever worn or damaged. Replacement filters are available from
your BLACK+DECKER dealer (cat. no. PVF110):
• Remove the old filters as described above.
• Fit the new filters as described above.
Maintenance
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT:
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
Problem
• Unit will not start.
• Battery will not charge.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK+DECKER help line at
1-800-544-6986.
Accessories
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING:
this tool could be hazardous.
BATTERY REMOVAL AND DISPOSAL
This product uses nickel-cadmium (Ni-Cd) rechargeable and recyclable batteries.
When the batteries no longer hold a charge, they should be removed from the Vac and
To assure product SAFETY and RELIABILITY, repairs, maintenance and
Troubleshooting
Possible Cause
• Battery not charged.
• Charger not plugged in. • Plug charger into a working
• Surrounding air
temperature too hot or
too cold.
The use of any accessory not recommended for use with
K
• Check battery charging
requirements.
outlet. Refer to "Important
Charging Notes" for more details.
• Check current at receptacle by
plugging in a lamp or other appliance.
• Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
• Move charger and tool to a
surrounding air temperature
of above 40 degrees F(4.5°C) or
below 105 degrees F (+40.5°C).
7
Possible Solution