Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL DATA
Type WX272L WX272L.X (2 - designation of
machinery, representative of Impact Wrench)
Rated voltage
No-load speed
Impact rate
Max torque
Chuck capacity
Machine weight (bare tool)
**X may be followed by one or two characters. All models
are the same except model number and trademark.
The suffix in models may be number from "1" to "999"
or English letter "A" to "Z" or "M1" to" M9" which means
different package or the various of accessories packed in
the package.
*** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage is
18 volts.
Category
10
20V Battery
20V Charger
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE:
This tool is intended for the fastening and loosening of
bolts, nuts and various threaded fasteners. This tool is not
intended for use as a drill.
20V Cordless Brushless Impact Wrench
All manuals and user guides at all-guides.com
WX272L WX272L.X**
20V
Max***
0-1300/2200/2900/min
0-2000/3200/4000 bpm
2655 in-Ibs (300 Nm)
1/2" (13mm)
2.43 lbs(1.1 kg)
Model
Capacity
WA3520
1.5Ah
WA3525
2.0Ah
WA3575
2.0Ah
WA3578
4.0Ah
WA3012
4.0Ah
WA3742
0.4A
WA3875
2.0A
WA3881
2.0A
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Removing the Battery Pack
Charging the Battery
Installing the Battery Pack
Checking the battery condition
NOTE: Fig. A4 only applies for the battery
pack with battery indicator light.
ASSEMBLY
Inserting and Removing Socket (not
supplied)
-Push the socket onto the anvil until the
detent pin locks it into place.
- To remove the socket, pull it away from
the anvil.
NOTE: Make sure the battery is removed
before changing accessories.
NOTE: Use only sockets designed for
impact wrenches. Always select the
correct size impact socket for nuts and
bolts.
Assembling the belt hook
OPERATION
Switch Lock
Set the direction of rotation selector
in the OFF (center lock) position
to lock the switch trigger and help
prevent accidental starting when not
in use.
Forward And Reverse Rotation Control
Position the direction of rotation
selector to the left of the switch
trigger for forward operation.
Position the selector to the right of
the switch trigger to reverse the
direction
WARNING: Never Change The
Direction Of Rotation When The
Chuck Is Rotating, Wait Until It Has
Stopped!
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. A4
See Fig.
B1, B2
See Fig.
C1, C2
See Fig. D1
See Fig. D2,
D3
EN
Publicidad
