Publicidad
Idiomas disponibles
Idiomas disponibles
Random orbit sander XS713
Safety instructions for random
orbit sander
1. ALWAYS DISCONNECT the sander cord
plug from the power circuit before
changing abrasive sheets.
2. USE DUST MASK. Wear a protective
mask to minimize breathing in the fine
dust created while sanding.
3. NEVER RUN SANDER with dust
container or dust collector assembly
removed. Dust could be blown into eyes.
4. USE PROPER SAFETY EQUIPMENT.
Wear safety goggles to protect your eyes.
5. SANDING OF LEAD-BASED PAINT IS
NOT RECOMMENDED. Lead-based
paint should only be removed
by a professional.
6. Use of this tool can generate and
disburse dust or other airborne particles,
including wood dust, crystalline silica dust
and asbestos dust. Direct particles away
from face and body. Always operate tool
in well ventilated area and provide for
proper dust removal. Use dust collection
system wherever possible. Exposure
to the dust may cause serious and
permanent respiratory or other injury,
including silicosis (a serious lung
disease), cancer, and death. Avoid
breathing the dust, and avoid prolonged
contact with dust. Allowing dust to get into
your mouth or eyes, or lay on your skin
may promote absorption of harmful
material. Always use properly fitting
NIOSH/OSHA approved respiratory
protection appropriate for the dust
exposure, and wash exposed areas with
soap and water.
Replacement parts
When servicing use only identical
replacement parts.
Exploded drawings and spare-part lists
can be found on our homepage:
www.flex-tools.com
Operating instructions
Foreword
The FLEX Random Orbit Sander is equipped
to accept (Ø 125 mm), "hook & loop" type
abrasives. This Random Orbit Sander is
suitable for coarse, medium or fine sanding
of wood, plaster, metal and plastics. It is ideal
for leveling wallboard joints, finishing
cabinets, fitting screens and doors and for
general finishing work in the shop.
To start and stop sander
CAUTION!
Make certain the switch is in the "O" position,
and the power source is the same as that
specified on the tool's nameplate.
1. Connect the tool to the power source.
2. The switch button, (A) fig. 1, is labeled "I"
and "O". Depress the "I" end of the switch
button to start motor. Depress the "O" end
of the switch button to stop motor.
9
Publicidad
