Enpuly MLG1 Manual Del Usuario página 6

EN
5.Move the nozzle slowly
along the teeth with the
lips slightly closed to avoid
splashing.
F. Note：
1.Select the cleaning mode first, then put the nozzle against
the gap between the teeth. Then press the start button and
close the lips slightly when using to avoid splashing water and
damaging the gums.
2. If you are using water flosser for the first time or your gums
are sensitive, please use the sensitive mode first and choose
the appropriate mode according to your personal needs after
getting used to it.
3.The nozzle should be close to the gap between the teeth, and
the angle can be slightly inclined to avoid direct contact with
the gums. Move the nozzle slowly along the teeth, and close
the lips slightly, keep the posture of leaning down and let the
water flow along the lips, so as not to wet the clothes.
✔ ✔ ✔
Kind tips:
When using the water flosser for the first time, there may be
slight bleeding, which is normal. You can use the periodontal
pocket nozzle to get used to it for a while and then choose
another nozzle.
G. Battery and charging status
Power indicator status
Green
Blue
Red
blinking red
6.Rinse teeth for 1-2 minutes
and clean water tank regularly.
❌ ❌
Charging status
When the power is 61%-100%
When the power is 21%-60%
When the power is 3%-20%
When the power is lower than 3%
(cannot be turned on at this time)
7
> > Precautions for Charging：
Please use USB A port power adapter (not included in
●
package) and the included USB A to USB C cable to charge
this product.
Ensure that the output voltage and current parameters of the
●
adapter are the same as the charging parameters of the product.
Please ensure that there is no water at the charging port and
●
ensure that the surface of the product is dry before charging,
otherwise it may be dangerous.
Open the charging port and connect the Type-c cable correctly
●
to charge the product after confirming that there is no water in
the charging port.
It usually takes about 4-5 hours to get this item fully recharged.
●
After fully charged, please remove the charging cable and
●
power adapter in time. Please cover the charging port cap.
5. Cleaning and Maintenance
Cleaning
It is recommended to wash thoroughly after each use and keep it
dry before storage to avoid the breeding of bacteria.
1.Close the water flosser.
3.You can use a mixture of
vinegar and water to clean
the inside of the nozzle and
tank, and then wipe off the
water stains with a dry cloth.
2.Hold the water tank, turn
the tank to the unlock sign,
and remove the tank.
4.Install the water tank and
turn it to the lock mark.
8
EN