Tabla de contenido
Publicidad
8. Coordinate data input to memory (/Dg)
/Dg 1234.567, -1234.123, 12.345, 12345678 [,SUM] CR LF
a
b
Data identifying code
N coordinate data
E coordinate data
Z coordinate data
Point number
9. Code Input to memory (/Dh)
/Dh ABC, DEF, ......, XYZ [,SUM] CR LF
a
b
Data identifying code
Up to 16 alphanumeric characters in 1 code. Up to 40 codes can be input to
memory
Setting commands
These setting commands can be used to perform the same operation from a
computer keyboard as from the SET keyboard.
"22.1 Modificación de las opciones del instrumento"
When the setting command (N) is transmitted from the host computer to the SET,
the SET transmits the reception condition code to the host computer. (ACK/NAK
communication control)
06H(ACK):Data communication has succeeded, request next command sending.
15H(NAK):Data communication has failed, request the same command sending.
For flow diagram:"Command transmit and data output"
Formats for setting commands
Each command needs CRLF (0DH, 0AH) or CR (0DH) at the end.
1.Set Distance measurement mode to Fine "s" (Xa)
2. Set Distance measurement mode to Fine "r" (Xb)
3.Set Distance measurement mode to Rapid "s" (Xc)
4.Set Distance measurement mode to Rapid "r" (Xd)
5.Set Distance measurement mode to Tracking (Xe)
6.Set H angle to 0 (Xh)
7.Set Azimuth angle from Backsight and Instrument station coordinates (Xi)
8.Set H angle right (HAR) (Xk)
9.Set H angle left (HAL) (Xl)
10. Replace the last measured coordinates as the new Instrument station
coordinates (Instrument station movement)
11.Change the starting position in Missing line measurement (Xo)
c
d
23. DETAILS OF DATA INPUT / OUTPUT
e
105
Publicidad
Tabla de contenido
