Publicidad
Idiomas disponibles
Idiomas disponibles
•
To select reverse rotation, push the forward/reverse
slider
2
to the right (when viewed from the chuck end).
nOTE: The center position of the control button locks the
tool in the OFF position. When changing the position of the
control button, be sure the trigger is released.
Fig. B
1
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Keyless Chuck (Fig. C)
WARNING: Make certain the lock-off button is
engaged to prevent switch actuation before
installing or removing accessories.
WARNING: Do not attempt to tighten drill bits (or
any other accessory) by gripping the front part
of the chuck and turning the tool on. Damage to
the chuck and personal injury may occur when
changing accessories.
To insert a drill bit or other accessory:
1. Grasp the rear half of the chuck
and use your other hand to rotate the front half
the counterclockwise direction, as viewed from the
chuck end.
2. Insert the bit or other accessory fully into the chuck, and
tighten securely by holding the rear half of the chuck
and rotating the front portion in the clockwise direction
as viewed from the chuck end.
Fig. C
3
3
2
with one hand
3
in
3
Torque Control (Fig. D)
This tool is fitted with a torque adjustment collar
the operating mode and to set the torque for tightening
screws. Large screws and hard workpiece materials require a
higher torque setting than small screws and soft workpiece
materials.
For drilling in wood, metal and plastics:
1. Set the collar to the drilling position symbol
For screwdriving, set the collar to the desired setting.
if you do not yet know the appropriate setting,
proceed as follows:
2. Set the collar to the lowest torque setting.
3. Tighten the first screw.
4. If the clutch ratchets before the desired result is
achieved, increase the collar setting and continue
tightening the screw. Repeat until you reach the correct
setting. Use this setting for the remaining screws.
Fig. D
Dual Range Gearing (Fig. E)
The dual range feature of your drill allows you to shift gears
for greater versatility.
1. To select low speed, high torque setting (position 1),
turn tool off and permit to stop. Slide gear shifter button
6
away from the chuck.
2. To select high speed, low torque setting (position 2),
turn tool off and permit to stop. Slide gear shifter button
towards the chuck.
6
nOTE: Do not change gears when tool is running. If you
are having trouble changing gears, make sure that the dual
range gear button is either completely pushed forward or
completely pushed back.
Fig. E
English
5
to select
6
5
7
Publicidad
