Fanimation AIREFLEX LP7675 Manual página 13

1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
2. Assemble the light kit to the support bracket using
the two key slots in the light kit. Replace the previously
removed screw and securely tighten all three screws.
(Figure 2)
3. Remove one of the three screws in the light kit.
Retain the screw for later and slightly loosen the
remaining two screws. (Figure 3)
4. Connect the 2 single pin connectors from the
LED assembly to the 2 single pin connectors from
motor assembly. (Figure 4)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
5. Assemble the LED assembly to the light kit using
the two key slots. Replace the removed screw from
Step 3 and secure all three screws. (Figure 5)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
How to Assemble Your Light Kit
Motor
Assembly
Motor
Assembly
Light Kit
LED Assembly
LED
Assembly
Light Kit
13
Figure 1
Light Kit
Figure 2
Figure 3
Motor
Assembly
Figure 4
Figure 5