Publicidad
Idiomas disponibles
Idiomas disponibles
DS 59160 IN / DS 59190 IN
experience nor knowledge; unless they make it down
control of a responsible or professional for the use of the
appliance.
• WARNING: In order to ensure your children's safety,
please keep all packaging (plastic bags, boxes,
polystyrene etc.) out of their reach.
• Children should be supervised to ensure that they do not
play with the product.
(2)NOTICE
1. Thank you for choosing our cooker hood. Please read the instruction manual carefully before use.
2. The installation work must be undertaken by a qualified and competent fitter.
3. The manufacturer disclaims all liability for any damage or injury caused as a result of not following
instructions for installation contained in the following text.
The cooker hood is used on 220/240v, 50Hz.
(3)FEATURE
1. The cooker hood uses high quality materials, and is made with a streamlined design.
2. Equipped with a large power low noise electric motor and centrifugal leaf, it produces strong suction, low
noise, non-stick grease filter and easy to clean.
3. With the isolated low voltage circuit board control, 12vDC input, the lights are therefore safer.
4. Special wind tunnel construction and oil collector design, free dirt will be absorbed in a second.
(4). INSTALLATION
4.1 For optimum performance the extractor hood should be installed
approximately 65-75 cm above the ho
4.2 The hood is supplied with screws and rawlplugs which are suitable for
most types of wall and ceiling. However it is advisable to consult a qualified
technician to ensure that the materials are right for your wall or ceiling. The
wall or ceiling must be strong enough to support the weight of the hood.
4.3 Electrical connection: The mains current must match the current stated on the characteristics label
situated inside the Hood. If the plug included is correct, connect the hood to a socket which meets safety
requirements in an accessible location. If the hood includes a direct mains connection, use a double pole
switch with a minimum distance between open contacts of 3 mm (accessible).
4.4 Study Figure A.
4.5 For wall installation drill three 8 mm holes every 100 mm in line with the hook of the hood.
4.6 Insert the rawlplugs.
17
Publicidad
