Publicidad
Idiomas disponibles
Idiomas disponibles
Washing machines must be connected to the water inlet. Use the enclosed new fittings
instead of old ones.
During quality control, water injection tests are carried out before the washing machine
leaves the factory, so there may be water left inside as well as on the seals and door
panel. This is normal.
Water inlet connection
1. The water supply pressure must be between 30 kPa and
1000 kPa.
2. When connecting the water inlet pipes to the valves,
the thread must not be damaged.
3. If the water supply pressure exceeds 1000 kPa, a
pressure reducer must be installed.
• The connectors at both ends of the pipe have gaskets
to prevent water leakage.
• Open the tap and check if the connectors are leaking.
• Regularly inspect the pipes and replace them if
necessary.
• Check that the pipes are not damaged or twisted
together.
Connection of water inlet pipes and taps
1. Check the rubber seals on both sides of the
hose. Put a rubber gasket on the threaded
fittings of each hose to prevent leakage.
rubber gasket
Water hose (to the
water inlet of the
washing machine)
water pipe
connector rubber
gasket
2. Manually connect the water supply hoses
firmly to the water taps and then tighten
another 2/3 turn with pliers.
-
Connect the blue hose to the water tap.
WARNING
Do not overtighten. Damage to
•
the connection may occur.
7
Use the standard tap
Standard tap
Long tap
Square tap
V.2
Publicidad
