Problem
The washing
machine will not
start
The display shows
"UE" during spinning
Display shows "IE"
during water intake
Display shows "OE"
during water outlet
The display indicates
"DE" which is a door
problem.
The display indicates
"tE" which is a non-
heating problem.
Display shows "FE"
during continuous water
input
The display indicates "LE"
or "CE'' when the drum
does not rotate.
Excessive foam
Troubleshooting
Checks
Check if the on/off or start/pause button has
been pressed.
Is the washing machine plugged in?
Is there a power failure?
Check whether the leakage protector is cut off?
Check whether the transport bolts have been
removed.
Is the machine installed stably?
Are the garments too small or too light?
Are the locking nuts under the feet tight?
Check if the tap is turned off
Check if the water supply is turned off or the
water pressure is too low
Are the water inlet pipes frozen?
Are the filters blocked?
Are the water outlet pipes positioned too high?
Are the water outlet pipes frozen? Are the
water outlet pipes blocked?
Is the floor drain blocked?
Check if the washing machine has started
without closing the door properly.
Remove the plug and call the after-sales service.
Turn off the tap, remove the plug and call the after-sales service.
Turn off the tap, remove the plug and call the after-sales service.
- Check if too much detergent
has been added
- Check if too much detergent
has been added
Solutions
Press the on/off or start/pause button.
Plug in the power plug.
Please wait.
Open the leakage protector.
Remove the transport bolts.
Place the machine on a stable floor.
Add more garments.
Tighten the lock nuts.
Open the tap.
Please wait.
Use hot water to thaw the pipes. Remove the
filters and clean them.
Pull out the water outlet pipes and make sure
that the height is 1 m max.
Use hot water to thaw the pipes. Remove
foreign particles and clean the pipes. Clean the
floor drain.
Check that the door is properly closed.
Add a reasonable amount of detergent. Use
detergent correctly.
26
V.2