IP Cleaning 505 Manual De Instrucciones página 14

1.2 - SERIAL NUMBER AND CE MARKING
Always ensure that the machine is provided with a name plate giving
the serial number and CE marking in the position shown in Fig. 1.
On the contrary advise your dealer immediatly.
1.3 - FOREWORD
The purpose of this manual is to inform the operator of the basic rules,
safety rules and criteria which must be observed when using,adjusting
and maintaining the machine. The machine has been developed and has
been developed and manufactured to ensure an excellent performance
and the utmost comfort and ease of operation in a variety of working
conditions. Before delivery, the machine has been checked at our
factory and by our dealer to make sure it is handed over to you in perfect
working order. To maintain the machine in this condition and ensure
problem free operation, it is essential to follow the routine maintenance
instructions given in this handbook.
1.4 - UTILIZATION FIELD
The machine, composed of a brush and a suction system, is to be used
EXCLUSIVELY to clean dry surfaces. Any other use could be cause
of damage to people or things and is therefore PROHIBITED.
1.5 - UNPACKING THE MACHINE
Unpack the machine with the utmost care;avoid carrying out any
operation that could damage it. Once it has been unpacked,check
whether it is damaged. If you notice that it is not in correct working
order, DO NOT use it and inform your dealer.
For packaging and transport purposes,some parts and accessories are
supplied disconnected from the machine. To assemble them,carefully
follow the instructions given in the relevant sections.
Contents of package:
N° 1 Machine.
N° 1 Side brush.
N° 1 Instructions and spareparts manual.
N° 2 Ignition keys.
N° 1 Declaration of conformity.
N° 1 Warranty slip.
In the case in which one of the above mentioned parts is missing, place
inform your dealer straight away.
Take care to keep the packaging materials (bags, cartons,
pallets, hooks, etc) out of the reach of children.
For security reason during the transport, the ignition keys
as been fixed to the handle.
1.6 - CONSOMABLES
Gear motor: MOVIBLAK 300 lithium grease with similar
features.
Serial number
Fig. 1
ENGLISH (Translation of original instructions)
Battery: Distilled water.
Engine: UNLEADED petrol. Motor oil.
2.1 - PREPARING THE MACHINE FOR
OPERATION
(Version with motor - Version with engine)
2.1.1 - Mounting the side brush
(Version with motor - Version with engine)
- Switch the brush lift lever pos. 1 Fig. 3, to OFF.
- Remove the screw from the side brush drive shaft.
- Fit the brush on the shaft.
- Screw on the screw and washer.
2.1.2 - Mounting the handlebar
(Version with motor - Version with engine)
- Loosen the handlebar fixing screws.
- Position the handlebar in work position.
- Tighten the handlebar fixing screws.
2.1.3 - Mounting the bonnet
(Version with motor - Version with engine)
Prepare the battery or the gas motor before proceeding to the assem-
bling of the cover. Once you have done this:
- Loosen the bonnet fixing handwheels.
- Position the bonnet on the machine.
- Tighten the handwheels.
2.2 - PREPARING THE BATTERY
The battery must be prepared before it is mounted on the
machine. This simple precaution will prevent the machine
from being damaged by the electrolytic liquid of the
battery.
Always prepare the battery in a sufficient ventilated envi-
ronment. Do not smoke or use naked flames during this
operation (see the section on battery maintenance).
Once the battery has been charged, make sure the electro-
lytic liquid containers are stored in a safe place AWAY
FROM CHILDREN.
Fig. 2/A
Fig. 2/B
GB
5