Installation
Cable-Association Procedure
When you initially install the Hub, you must "associate" it
with the host computer. To do this, connect the Hub to
your computer using the provided USB cable. This "cable
association" procedure allows the computer and Hub to
share information that is used to establish a secure wireless
connection.
1. Plug the power supply into the wall, and then plug the
DC connector into the Hub.
2. Attach the Hub to your computer using a standard USB
cable (mini-B to USB-A connector).
a. Plug the "Mini B" connector into the port next to the
b. Plug the "USB A" connector into a USB port on the
c. After a few moments, the Windows "Found New
Note for Windows Vista Users: You will not see the dialog
noted in step 3. Proceed to step 4.
3. There are four separate drivers to install in this step:
a. Belkin Cable Association Device
b. Belkin Cable Association RCI Device
c. Belkin Cable Association DFU Interface
d. Belkin Cable Association Interface
5427ea_F5U302ea_man.indb 7
Hub antenna.
host computer.
Hardware Wizard" will launch.*
EN-7
1
2
3
4
5
6
12/19/2007 3:40:29 PM