Publicidad
Idiomas disponibles
Idiomas disponibles
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Plug power supply cord to a grounded wall outlet
(Figure 3).
Grounded
3 Hole Outlet
Ground Pin
WARNING: Do Not Operate With Damaged
Power Cord. Do Not Modify Plug. Unplug Power
Cord Before Servicing Machine.
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
combustible dusts are present.
2. Release the handle from the upright position by
lifting the handle release lever and lowering the
handle (Figure 4).
NOTE: Handle does not lock while in lowered position.
It is designed to allow burnish head to float freely.
Speedshine 1200/1600/2000 (12- -06)
FIG. 3
FIG. 4
3. Start machine by pressing the safety lock button
and turning the twist grips forward. Release thumb
from the safety lock button once machine starts
(Figure 5).
ATTENTION: Use caution when starting out.
Machine will jolt when twist grips are turned.
4. Begin burnishing by pushing the machine forward
or using a "W" pattern motion.
FOR SAFETY: When using machine, stay clear of
spinning pad.
SPRAY BUFFING INFORMATION: Spray buffing is
only recommended with the 1200 model.
The 1600 and 2000 models should not be used for
spray buffing; circuit breaker may trip or machine
overloading may occur. The 1600 and 2000 models
require more power at increased amp draw due to
higher speeds.
5. To prevent the possibility of motor overload and
causing circuit breaker to trip, periodically check
pad for excessive soil build-up. Turn pad over,
clean or replace when necessary.
NOTE: If circuit breaker should trip, unplug power
cord. Wait at least 15 seconds before resetting
breaker switch. While waiting determine reason why
circuit breaker tripped (Figure 6).
OPERATION
FIG. 5
FIG. 6
7
Publicidad
