Publicidad
Idiomas disponibles
Idiomas disponibles
A. Open the rear cover bar by removing the screws.
B. Use the open wrench to remove the screws from pipe connector.
C. Take out the 1.18 LPG injector from the part bag and replace the 2.0 NG injector by the 1.18 LPG injector.
D. Loosen the screws and adjust the diameter of the air inlet hole to 0.32"
E. Fix the pipe connector and the gas inlet by the screws.
F. Fix the rear cover bar by the screws
G. Install the back cover plate by the screws
Injector diameter for oven burners:
NG ---2.0
LPG --- 1.18
IMPORTANT: Keep the injectors removed from the range for future use.
STEP 5: Oven Valve Adjustment
To set the oven valve for LP usage, you will need to adjust the regulating screw.
Follow the instructions in this section.
WARNING
If the orifice is adjusted to be too small, the oven burner flame might be off during normal use.
Need to re-adjust the orifice in case this is happened.
Oven control
Regulating screw
A. Turn oven control knob to 500F position, pull out the knob to access the regulating screw on the valve.
B. Use a small flat head screwdriver to adjust the regulating screw. Turn the screw clockwise and tighten it to the
maximum.
C. Put back the knob.
21
Publicidad
