Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble the Blades and Light Kit
1. Remove the blade bushing cover (Figure 1).
2. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade
arm. With a Phillips screwdriver, tighten 3/16-24 x
8 mm washer head screws and fiber washers to
secure the blade to the blade arm (Figure 2).
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
3. Remove and discard rubber motor stops. (Figure 3)
4. Secure the blade holders to the motor support
using the 1/4-20 x 14mm screws through the holes
located on the top of the motor support (Figure 4).
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
BLADE BUSHING COVER
3/16-24 x 7.5mm W ASHER
HEAD SCREW AND FIBER
W ASHER (3 each per blade)
BLADE HOLDER
HARDWARE USED:
3/16-24 x 8mm
W ASHER HEAD
SCREWS
FIBER W ASHER
HARDWARE USED:
1/4-20 x 14mm
SCREWS
9
Figure 1
BLADE
Figure 2
x 21
x 21
RUBBER
MOTOR STOPS
MOTOR
ASSEMBY
Figure 3
1/4-20 x 14mm SCREWS
(2 per assembly)
BLADE HOLDER
MOTOR SUPPORT
Figure 4
x 11
Publicidad
