Publicidad
Idiomas disponibles
Idiomas disponibles
Anleitung Euro 2200-1
19.02.2003
Smoking is prohibited during
III, IV, VI and VII suffer damage
the spraying operation and in
to any pressure-bearing walls,
the work room. Paint vapours
resulting in them being taken
are highly flammable.
out of operation in accordance
Make sure there are no open
with Section 13 Paragraph 3 of
the German Pressure Vessel
fires or open lights in the work
Act, the operator has to notify
room. Sparking machines are
not to be used.
the supervisory authorities and
discuss what action is to be
Do not keep or consume food
taken.
and drink in the work room.
Paint vapours are harmful.
The work room has to be
Putting the compressor
bigger than 30 m
3
and have
into operation
sufficient ventilation for
spraying and drying. Never
Assembling the wheels (1):
spray into the wind.
Fit the wheels as shown in
It is always imperative to
Figure 1.
observe the regulations of your
1
local police authorities when
spraying combustible or
hazardous substances.
Never process media such as
white petroleum spirit, butyl
alcohol and methylene chloride
with the PVC pressure hose
(reduced life span).
Operation of pressure
vessels in accordance
with the pertinent
Assembling the rubber buffer
pressure vessel
Fit the supplied rubber buffer to
regulations
the support foot as shown in
(e.g. Section 13 of the German
Figure 2.
Pressure Vessel Act)
2
1. An operator of a pressure
vessel is required to keep the
pressure vessel in good
working order, to operate it
properly, to supervise its use,
to carry out essential
maintenance and repair work
immediately, and to introduce
essential safety measures
according to requirements.
2. The supervisory authorities
Replacing the oil filter and
may order essential safeguards
installing the air filter (fig. 3)
from case to case.
Use a screwdriver to remove the
3. A pressure vessel may not be
oil filler plug and insert the
operated if it has any defects
supplied stopper (2) in the
which constitute a danger to
opening.
employees or third parties.
Important! Check the oil level.
Screw the air filter (1) into the
4. If pressure vessels of groups
11:29 Uhr
Seite 9
GB
hole in the side of the compressor
pump.
3
Connecting to the power
supply:
The EURO 2200 compressor is
equipped with a power cable and
an earthing-pin plug for
connection to any 230 V ~ 50 Hz
earthing-contact socket outlet with
a 16 A fuse. Long supply lines,
extensions, cable reels and
similar cause voltage dips and
may prevent the motor from
starting. Sluggishness makes
starting difficult at low
temperatures under freezing
point (0°C).
Explanation of the compressed
air fittings
1 Pressure switch
2 Safety valve
3 Pressure gauge (to indicate the
vessel pressure)
4 Pressure gauge (to indicate the
set pressure)
5 Pressure reducing valve
(pressure setting)
6 On/Off switch
4
9
Publicidad
