Publicidad
Idiomas disponibles
Idiomas disponibles
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• Three wire connectors (supplied)
WARNING
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 4). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check
mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should
you be interrupted.
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any
accessories designated specifically for use with this
product by Fanimation. Substitution of parts or
accessories not designated for use with this product
by Fanimation could result in personal injury or
property damage.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
• One wire stripper
• One 1/4" blade
screwdriver
Unpacking Instructions
FAN MOTOR
ASSEMBLY
CEILING
CANOPY
BLADE SET (4)
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be a
3-conductor (2-wire with ground) of the following size:
Installed Wire Length
U
5
0
p
o t
. t f
5
0
0
0
1 -
. t f
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing contact your local retailer.
• Fan Motor Assembly
• Hanger Bracket Assembly with
screws
• Downrod/Hanger Ball Assembly
• Ceiling Canopy
• Canopy Screw Cover Assembly
• Motor Coupling Cover Assembly
• Blade Set (4)
• Upper Light Kit Plate
• Lower Light Kit Cover
• One 50W Halogen Light Bulb
• TR24WH Hand-held Remote
• Receiver Unit
HANGER
BRACKET
ASSEMBLY
W/SCREWS
CANOPY
SCREW
COVER
ASSEMBLY
ONE 50- WATT
HALOGEN
LIGHT BULB
3
Materials
Wire Size A.W.G.
1
4
1
2
• Hardware bags:
– 3/16-24 x 12.5mm
(blade to motor)
Washer Head Screw
– 3/16" Fiber Washer
(blade to motor)
– Phillips Screwdriver, 4"
– Four Wire Connectors
– Balance Kit
DOWNROD/
HANGER BALL
ASSEMBLY
TR24WH
Hand-held Remote
MOTOR
COUPLING
COVER
UPPER LIGHT
KIT PLATE
HARDWARE BAG
RECEIVER
UNIT
LOWER LIGHT
KIT COVER
Publicidad
