Publicidad
Step 5
Turn six BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Now, slide the END MOLDINGS (Z) onto the ENDS (A
å
and B). To do this, line up the grooves in the MOLDINGS
over the heads of the SCREWS in the ENDS. Using your
hands, apply pressure on the MOLDINGS as you guide
the MOLDINGS onto the ENDS.
NOTE: If the MOLDINGS come up off of the SCREWS,
å
remove them and slide them on again.
Z
These edges
should be even.
Page 10
B
BLACK 9/16" FLAT HEAD SCREW
(6 used in this step)
A
Shoulder
32S
418656
These edges
should be even.
Z
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
www.sauder.com/services
Publicidad
