Publicidad
Step 10
Separate the NARROW EXTENSION SLIDES (DD) from the NARROW EXTENSION RAILS (CC) as shown in the upper
å
diagram below. Be prepared, the parts are greasy.
Fasten the NARROW EXTENSION RAILS (CC) to the ENDS (A and B) and UPRIGHTS (C2 and D2). Use eight GOLD 5/16"
å
FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END and UPRIGHT. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
CC
Open end
www.sauder.com/services
DD
Push the black lever in and pull the SLIDE from the RAIL.
C2
CC
Open end
CC
Open end
CC
A
B
418656
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Open end
CC
D2
Page 15
Publicidad
