Publicidad
Step 9
NOTE: Before beginning this step, separate the NARROW EXTENSION SETS (CC and DD) from the WIDE EXTENSION
å
SETS (AA and BB). Do not confuse these SETS once they are separated.
Separate the WIDE EXTENSION SLIDES (BB) from the WIDE EXTENSION RAILS (AA) as shown in the upper diagram
å
below. Be prepared, the parts are greasy.
Fasten the WIDE EXTENSION RAILS (AA) to the ENDS (A and B) and UPRIGHTS (C2 and D2). Use eight GOLD 5/16"
å
FLAT HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that line up with the holes in the ENDS and UPRIGHTS. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
C2
1
Open end
Open end
Page 14
BB
Push the black lever in and pull the SLIDE from the RAIL.
4
3
2
AA
3
B
2
1
AA
1
2
3
AA
A
4
D2
4
4
418656
AA
Open end
1
2
AA
3
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
www.sauder.com/services
Open end
3S
Publicidad
