Husqvarna 450 Rancher Manual De Usuario página 10

Note:
If the clutch cover is not easy to remove,
tighten the bar nut, engage the chain brake and
release. A click is heard if it is released correctly.
3. Assemble the guide bar onto the bar bolts. Move the
guide bar to its most rear position.
4. Install the saw chain correctly around the drive
sprocket and put it in the groove on the guide bar.
WARNING:
gloves when you assemble the saw
chain.
5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
6. Align the hole in the guide bar with the chain adjuster
pin and install the clutch cover.
7. Tighten the bar nut finger tight.
8. Tighten the saw chain. Refer to
of the saw chain on page 29 for instructions.
9. Tighten the bar nut.
To reset the chain brake
If the clutch cover is removed accidentally while the
chain brake is locked, the chain brake must be unlocked
so the clutch cover can be assembled without binding to
the clutch drum.
CAUTION:
under tension. Use care when resetting the
chain brake.
Note:
Do not hold the brake band while attempting to
reset it.
Introduction
WARNING:
safety chapter before you use the product.
10
Always use protective
To adjust the tension
The chain brake spring is
Operation
Read and understand the
1. Align the notches on the bar tool so that they fit over
the brake rotating link.
2. To reset the brake, rotate the link clockwise until it
stops. The front link will be in its downward rotated
position when the chain brake is unlocked.
To do a function check before you use
the product
1. Make sure that the chain brake operates correctly
and that it is not damaged.
2. Make sure that the right hand guard is not damaged.
3. Make sure that the throttle lockout operates correctly
and that it is not damaged.
1286 - 012 - 08.03.2023