Descargar Imprimir esta página

Husqvarna 450 Rancher Manual De Usuario página 28

Ocultar thumbs Ver también para 450 Rancher:

Publicidad

Idiomas disponibles

Idiomas disponibles

difference in height between the two gives the cutting
depth (depth gauge setting).
When you sharpen the cutter, think about the following:
Filing angle.
Cutting angle.
File position.
Round file diameter.
It is not easy to sharpen a saw chain correctly without
the correct equipment. Use Husqvarna file gauge. This
will help you to keep maximum cutting performance and
the kickback risk at a minimum.
WARNING:
increases a lot if you do not follow the
sharpening instructions.
Note:
To sharpen the saw chain on page 27
Refer to
for information about sharpening of the saw chain.
28
A
B
The force of the kickback
To sharpen the cutters
1. Use a round file and a file gauge to sharpen the
cutting teeth.
Note:
Accessories on page 34
Refer to
for information about which file and gauge that
Husqvarna recommends for your saw chain.
2. Apply the file gauge correctly on to the cutter. Refer
to the instruction supplied with the file gauge.
3. Move the file from the inner side of the cutting teeth
and out. Decrease the pressure on the pull stroke.
4. Remove material from one side of all the cutting
teeth.
5. Turn the product around and remove material on the
other side.
6. Make sure that all cutting teeth are the same length.
General information about how to adjust the
depth gauge setting
The depth gauge setting (C) decreases when you
sharpen the cutting tooth (A). To keep maximum
cutting performance you must remove filing material
from the depth gauge (B) to receive the recommended
depth gauge setting. See
for instructions about how to receive the correct depth
gauge setting for your saw chain.
Accessories on page 34
A
C
B
1286 - 012 - 08.03.2023

Publicidad

loading

Este manual también es adecuado para:

445