Husqvarna 450 Rancher Manual De Usuario página 14

2. Pull the start/stop switch (A) out and up, to set it in
choke position.
B
3. Push the air purge bulb (B) approximately 6 times or
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
4. Push the start/stop switch down (C).
To start the product on page 14 for
5. Continue to
more instructions.
To start the product
WARNING:
a stable position when you start the product.
WARNING:
idle speed, speak to your servicing dealer
and do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your right foot into the footgrip on the rear
handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING:
rope around your hand.
5. Pull the starter rope handle quickly and with force.
14
A
C
You must keep your feet in
If the saw chain rotates at
Do not twist the starter
CAUTION:
rope to full extension and do not let go of
the starter rope handle. This can cause
damage to the product.
a) If you start your product with a cold engine, pull
the starter rope handle until the engine fires.
Note:
You can identify when the engine fires
through a "puff" sound.
b) Disengage the choke.
6. Pull the starter rope handle until the engine starts.
7. Quickly disengage the throttle trigger lockout to set
the product to idle speed.
8. Move the front hand guard rearward to disengage
the chain brake.
9. Use the product.
To stop the product
1. Push the start/stop switch down to stop the engine.
Pull stroke and push stroke
You can cut through wood with the product in 2 different
positions.
• To cut on the pull stroke is when you cut with the
bottom of the guide bar. The saw chain pulls through
the tree when you cut. In this position you have
Do not pull the starter
1286 - 012 - 08.03.2023