Publicidad
Idiomas disponibles
Idiomas disponibles
You must first depress the push lever (upward position) where you wnat to drive a
nail and then pull the trigger. After the each nail is driven, completely release the
trigger and lift the tool off the work surface. An FULL SEQUENTIAL ACTUATION
MECHANISM (SEQUENTIAL TRIP MECHANISM) may reduce the possibility of bodily
injury to you or others in the work area. This is because it is less likely to drive an
unwanted nail if you keep the trigger pulled and accidentally bump the push lever
against yourself or others.
An OPTIONAL SEQUENTIAL TRIP MECHANISM may also reduse the speed of
operation compared to the standard contact trip mechanism.
NOTE:
● If all warnings and instructions are followed, safe operation is possible with all three
systems: SINGLE ACTUATION MECHANISM, CONTACT ACTUATION MECHANISM and
FULL SEQUENTIAL ACTUATION MECHANISM.
● Always handle nails and package carefully. If nails are dropped, collating bond may be
broken, which will cause mis-feeding and jamming.
● After nailing:
1) disconnect air hose from the Nailer;
2) remove all nails from the Nailer;
3) supply 5 – 10 drops of Hitachi pneumatic tool lubricant into the air plug on the Nailer;
and
4) open the petcock on the air compressor tank to drain any moisture.
ADJUSTING THE NAILING DEPTH
● When adjusting the Adjuster, be sure to remove your finger from
the trigger and disconnect the air hose from the nailer.
To assure that each nail penetrates to the same
depth, be sure that:
1) the air pressure to the Nailer remains constant
(requlator is installed and working properly),
and
2) the Nailer is always held firmly against the
workpiece.
If nails are driven too deep or shallow into the
workpiece, adjust the nailing in the following order.
1 DISCONNECT AIR HOSE FROM NAILER.
2 If nails are driven too deep, turn the adjuster
to the shallow side.
Adjustments are in half-turn increments.
WARNING
Adjuster
English
15 Disconnect
air hose
21
Publicidad
