SpeedEPart 45-512-100 Manual Del Usuario página 6

13. Assemble the two INNER hitch braces to the flow control
mounting tube using a 1/4" x 1-3/4" hex bolt and a 1/4"
nylock hex nut. DO NOT TIGHTEN YET. See figure 8.
14. TIGHTEN all nuts and bolts assembled up to this point.
Do not collapse the tubes when tightening.
1/4 x 1-3/4
HEX BOLT
FIGURE 8
15. Assemble the hopper strap to holes in top of hopper
using two 1/4" x 2" hex bolts, small washers, nylon
washers, and 1/4" nylock nuts. See figure 9.
FIGURE 9
1/4 NYLOCK NUT
1/4-20 x 2 HEX BOLT
SMALL WASHER
NYLON WASHER
1/4 NYLOCK NUT
ENGLISH
16. Calibrate the flow control setting. (See figure 10).
a. Push flow control arm to "OFF" position.
b. Slide flow control mounting bracket along tube until
closure plate in bottom of hopper just closes.
c. Snug the 1/4" nylock hex nuts just enough to hold
flow control mounting bracket in place.
d. Set adjustable stop at "5". Pull flow control arm
against stop. Verify that closure plate has opened
about half way.
e. If closure plate does not open half way, adjust
position of flow control mounting bracket until closure
plate will open about half way at "5" and will close
completely in the "OFF" position. Tighten the 5/16"
nylock hex nuts.
FLOW
CONTROL
ARM
ADJUSTABLE
STOP
(SETTING "5")
FIGURE 10
6