Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
IMPORTANT!
To ensure safe operation of your stroller, please
follow these instructions carefully. Please keep these instructions for future
reference.
IMPORTANT!
Before assembly and each use, inspect this product for
damaged hardware, loose joints, missing parts or sharp edges. NEVER use if
any parts are missing or broken.
IMPORTANT!
Adult assembly is required.
Remove stroller from box. The front wheel
and rear wheels
be installed prior
MUST
to use.
FRONT WHEEL
To attach the front wheel, unfold stroller as
described in the section following:
• Unlock the release lever (Fig. 1a) and
1)
unfold stroller frame by pulling upward
on the stroller handle until the frame
locks (Fig. 1b).
• Slide the front wheel onto the front fork
2)
(Fig. 2).
5
5
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
3)
4)
REAR WHEELS
5)
Fig. 1a
TIRES
Fig. 1b
6)
Fig. 2
• Slide the retainer plate onto the front
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel (Fig. 3).
• With the wheel in position, tighten the
axel nuts and tighten with standard
crescent, box, or open end wrench. You
should feel significant resistance and
the wheel should be held tightly in place
(Fig. 4).
• Rest the stroller upside down, on the
handle.
• Press the rear wheel posts into the rear
frame hub until it clicks into place (Fig. 5).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
• Check the pressure before using the
stroller.
above the maximum
DO NOT INFLATE
recommended inflation pressure that
is on the side of the tire. Over inflation
may cause the tire to blowout and could
result in serious injury.
Only use hand pump.
NOTE:
air compressor to inflate
DO NOT USE
the tire.
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Front Fork
Slot
Axel and Hub
Retainer Plate
Axel Nut
Fig. 3
Fig. 4
Fig. 5
6
6
Publicidad
