Tool Description; Technical Specification; Symbols; Intended Use - Festool DOMINO DF 500 Manual De Instrucciones

8
accidental contact. If the slides of the fence do not
move freely, have the tool serviced immediately.
i) Wait for the cutter to stop before setting the tool
down. An exposed cutter may engage the surface
leading to possible loss of control and serious in-
jury.
Health hazard by dust
Various dust created by power
sanding, sawing, grinding, drilling and oth-
er construction activities contains chemicals
known (to the State of California) to cause
cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and
other masonry products, and
• arsenic and chromium from chemically-treated
lumber.
The risk from these exposures varies, depending
on how often you do this type of work.
To reduce your exposure to these chemicals:
work in a well ventilated area, and work with
approved safety equipment, such as dust
masks that are specially designed to fi lter
out microscopic particles. Wash hands after
handling.
TO REDUCE THE RISK OF INJURY, USER
MUST READ INSTRUCTION MANUAL.

Tool description

Technical specifi cation
Power
Speed (no load)
Mortising depth, max.
Mortising width, max. 23 mm (0.9") +bit diameter
Mortising bit range
Connecting thread of drive shaft
Weight (excluding cable)
Degree of protection
All metric dimensions are binding. Mortising bit
dimensions are critical for safe operation, and are
presented in metric units only.
V
A
Hz
~
n
0
rpm
Ø
The Domino tenon jointer is designed to produce
mortises in soft and hard wood, chip board, plywood
and fi ber boards. All applications beyond this are
regarded as improper use. The tool should not be
altered or used for any other purpose other than as
specifi ed in these operating instructions. Using the
tool in contravention to this manual will void your
warranty and may lead to injury.
liable for damages and accidents resulting from
misuse or abuse of this tool.
420 W
The pictures for the functional description are on
25,500 rpm
a fold-out page at the beginning of the instruction
28 mm (1.1")
manual. When reading of the manual you can fold
out this page for having always an overview of the
4/5/6/8/10 mm
machine.
M6 x 0.75
[1.1]
3.2 kg (7 lbs)
[1.2]
/ II
[1.3]
[1.4]
[1.5]
[1.6]
[1.7]
[1.8]
[1.9]

Symbols

Volts
Amperes
Hertz
Alternating current
No load speed
Class II Construction
Revolutions or reciprocation per minute
Diameter
Note, Danger!
Wear ear protection!
Manual, read the instructions!
Wear a face mask for work which produces
dust!

Intended use

The user shall be responsible and

Functional description

Auxiliary handle
Mortise width dial
Fence high locking lever
Power switch
Main handle (barrel grip)
Plug it power inlet
Depth adjust lever
Depth adjust lock
Board thickness gauge