Publicidad
1.
Prepare the Site
2x6 Backing Material
Matériau de renfort 2x6
Material de refuerzo de 2x6
NOTICE: To properly secure the vanity, the top of the required 2x6 backing material
must be 32" (81.3 cm) from the finished floor.
Measure and mark 32" (81.3 cm) up from the floor. This will be the height from
the floor to the top of the 2x6 backing material.
Ensure there are no obstructions in the wall (such as wiring or plumbing) from
the marked height down to the floor. If there are obstructions, select another area
within the site to install the vanity.
NOTE: Extend the backing material beyond the width of the vanity to the nearest
stud. This will ensure proper support for the vanity.
Front-notch the studs 1-1/2" (3.8 cm) to ensure the 2x6 backing material is flush
against the studs.
Secure the 2x6 backing material to the studs with framing nails.
Rough-in the water supply and drain lines into the rough-in plumbing area of the
vanity.
NOTICE: To ensure proper support of the lavatory and alignment of the drawers:
The finished wall must be straight and plumb. The floor must be flat and
perpendicular to the finished wall.
Complete the finished wall. Make sure the finished wall is straight and plumb,
and the floor is flat and perpendicular to the finished wall.
NOTICE: Do not install any moldings that may inhibit the vanity from being flush
against the finished wall.
Kohler Co.
32" (81.3 cm)
5
1106935-2-B
Publicidad
