Hitachi ULTRAVISION Director's Serie Guia De Funcionamiento página 56

TV Guide On Screen
Screen 11:
Are the settings correct ?
If Yes the TV Guide On Screen
then press SELECT button to continue.
If No please make the necessary changes in order to
complete the TV Guide On Screen
Screen 12:
This shows that the setup procedure is complete
Use the CURSOR PAD
or if you are like to make changes select Back ;
Then press SELECT button to continue or finish.
Screen 13:
When a CODE for a VCR is not accepted then
the following message will appear. Check the
setup as mentioned then select Next.
For using and navigating the TV Guide On Screen
User Manual.
56
Screen 14:
TM
setup is complete,
TM
setup procedure.
NOTE: 1. The Plasma TV should be in standby mode
and to highlight Next
TM
System please refer to the included TV Guide On Screen
None of the Hitachi codes appeared to control your
VCR. What would you like to do now ?
1.- Try VCR configuration again to repeat the setup.
2.- Try alternate remote codes to see other code
alternatives that may solve the problem.
3.- Skip this step, will finish the TV Guide On Screen
setup; but will show an incomplete setup for your VCR.
in order to continually receive updated
program listings.
TM