Hitachi ULTRAVISION Director's Serie Guia De Funcionamiento página 6

How to set up your new HITACHI Plasma Television
AC CORD AND POWER SWIVEL CABLE INSTALLATION INSTRUCTION
The AC cord and power swivel cable (P50X901 only) provided with your new Plasma Television need to be
installed correctly to avoid their disconnection when rotating the TV on its Table Top Stand.
Located on the back of the TV are 2 plastic clamps to hold the AC cord and power swivel cable. Please follow
the instructions below.
³
Pass the AC cord through Clamp #1 and connect
it to the TV. Pull on the clamp to tighten the
AC cord to the TV.
·
Connect power swivel cable on one end to the
swivel slot of the Plasma Rear Panel. Connect
the other end to the swivel slot of the Table
Top Stand Base (P50X901 only).
»
The AC cord, power swivel cable and the signal
cables can all be held together with Clamp #2
(included on the accesories bag).
·
Swivel slot on Table Top
Stand Base (P50X901 only).
6
³
»
Clamp #2: Use this clamp to hold the AC cord, power
AC CORD
Clamp #1 : Pass the AC cord through this clamp ;
then pull the clamp to tighten the AC
cord to the TV.
·
Swivel slot on Plasma Rear Panel
(P50X901 only).
swivel connector and the signal cables.
Please assemble this Clamp on the middle
hole of the base metal.