CYBEX Sirona Gi i-Size Manual Del Usuario página 8

INSTALLATION OF THE NEWBORN INLAY
The Newborn inlay (1) allows the Sirona Gi i-Size to be used from 40 cm.
When your child reaches a height of 60 cm, it should be removed again.
1. To use the Newborn Inlay (1) with the child seat loosen the Shoulder belts
(3) and open the Belt buckle (4) .
2. Now take the Newborn inlay (1) and place it in the child seat.
3. Place the Shoulder belts (3) right and left next to the Headrest of the
newborn inlay (5), above the Side pads of the newborn inlay (6). Then,
guide the Lap belts (7) on the right and left through the cut-outs provided
between the Side pads (6) and the Seat surface of the newborn inlay (8).
4. The seat can now be used for your baby. The restraining process is
described in the user guide of the car seat.
Adjusting the headrest in an upward position makes it easier to insert
��
the newborn inlay. Make sure that the headrest has been returned to the
appropriate position before starting to drive.
CLEANING OF THE COVER
Before you wash the Newborn inlay (1), both foams must be removed. There
are openings in the fabric for this purpose.
The cover may only be washed at 30°C with a delicate wash program
��
otherwise it may result in discolouration of the cover fabric. Please wash
the cover separately from other laundry and do not dry it in the dryer or in
direct sunlight!
MANUFACTURER'S WARRANTY AND DISPOSAL REGULATION
CYBEX GmbH (Riedingerstr. 18, 95448 Bayreuth, Germany) gives you 3
years warranty on this product. The warranty is valid in the country where
this product was initially sold by a retailer to a customer. The contents of the
warranty and all essential information required for the assertion of the warranty
can be found on our homepage: go.cybex-online.com/manufacturer-
warranty-car-seats. If a warranty is shown in the article description, your legal
rights against us for defects remain unaffected.
Please observe the waste disposal regulations in your country.
EN
5