Publicidad
Idiomas disponibles
Idiomas disponibles
Carefully check the workbench after mounting to make sure
that no movement can occur during use. If any tipping, slid-
ing, or walking is noted, secure the workbench to the floor
before operating.
MOUNTING SPARK SHIELD ASSEMBLY
See Figure 6, page 12.
Attach the spark shield assembly and bracket to the wheel
guard using a clamp bracket, washer, and hex head bolt.
Tighten bolt securely.
Repeat above steps for the other side.
MOUNTING SPARK DEFLECTOR
See Figure 6, page 12.
Using the two phillips head screws, washers, and lock
washers, attach the spark deflector to the top of the wheel
guard.
WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
NOTICE:
Excessive pressure on a cold wheel may cause the wheel
to crack.
NOTICE:
Never sharpen or grind anything made of aluminum,
brass, or copper.
WARNING:
Do not use wheels rated less than the speed of this tool.
Failure to heed this warning could result in personal injury.
ASSEMBLY
Adjust the spark deflectors to within 1/16 in. (1.6 mm) of
the grinding wheel. Tighten screws securely.
MOUNTING WORK REST
See Figure 7, page 13.
Unscrew and remove the carriage bolt from the work rest
knob.
Attach the work rest to the inside of the wheel guard as
shown.
NOTE: As the diameter of the wheel decreases with use,
adjust the distance between the wheel and the work rest
to maintain 1/16 in. or less separation.
Tighten knob securely.
OPERATION
APPLICATIONS
This product has been designed only for the purposes listed
below:
Sharpening drill bits
Sharpening lawn mower blades
Sharpening chisels and flat screwdrivers
BASIC OPERATION
To be efficient and work as designed, your tools should be
kept sharp. Dull tools can and will cause accidents.
Bench grinders are ideal for sharpening tools such as chis-
els, planer blades, scissors, etc., and for removing rust or
corrosion. Grinders remove material rapidly so pressure is
the key to efficient grinding.
The proper way to sharpen a tool and avoid overheating is:
Keep the object in constant motion, moving it at an even
pace.
Never force a tool against the grinding wheel.
Keep the tool cool by using a pan of water.
The grinding wheel should rotate "into" the object being
sharpened.
NOTE: Excessive pressure may damage the tool, cause the
motor to overheat, and prematurely wear down the grinding
wheel.
ON/OFF SWITCH
See Figure 8, page 13.
The bench grinder features a front access On/Off switch for
convenience and safety.
9 — English
Publicidad
