Using The Remote Control; Installing The Unit; Plugging In - Pioneer XW-NAC3-K Manual De Instrucciones

Before you start

Using the remote control

The remote has a range of about 7 m at an
angle of about 30º from the remote sensor.
30°
30°
Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles
between the remote and the remote sensor
on the unit.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit's remote sensor.
• Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.
• Replace the batteries when you notice a fall
off in the operating range of the remote.
7 m

Installing the unit

• When installing this unit, make sure to put
it on a level and stable surface.
Don't install it on the following places:
– on a color TV (the screen may distort)
– near a cassette deck (or close to a device that
gives off a magnetic field). This may interfere
with the sound.
– in direct sunlight
– in damp or wet areas
– in extremely hot or cold areas
– in places where there is vibration or other
movement
– in places that are very dusty
– in places that have hot fumes or oils (such as
a kitchen)

Plugging in

After you've finished making all connections,
plug the unit into an AC outlet.
AC IN AC IN
1 Plug the supplied power cord into the AC
IN socket on the back of the unit.
2 Plug the other end into a power outlet.
Important
• Before making or changing any
connections, switch off the power and
disconnect the power cord from the AC
outlet.
01
7
En