Set Up Instructions; Location Of Your Dryer - Haier HLP141E Manual Del Usuario

SET UP INSTRUCTIONS

Tools and Parts Required for Installation:
• Philips Head Screw Driver
• Flat Head Screw Driver
• Electric Drill and 1/8 inch drill bit
• Stud finder (optional)
• (6) Wood screws for mounting plywood
• Plywood board; size 30 (h) by 24(w) inches or wood slats
Venting materials:
• 4 inch diameter metal exhaust rigid ducting and fittings or UL flexible metal
dryer vent hose, that should not exceed 6 feet.
• 2 additional hose clamps for ducting outside exhaust vent hose
• Metal Elbows or outdoor vents as needed.

Location of Your Dryer

First find a suitable location where you can mount the dryer on the wall and still
have access to 120 Volt outlets and exterior venting.
Vent to outside
Type: Electric dryer
Rating: Please refer to the rating label regarding detailed information
Size: 26.97x24.8x16.73(inch)
Capacity: 2.6 cu.ft.
Weight: 52.9lbs(24kg)
• Check dryer size and ensure a good location for the dryer installation on a
wall where you can mount the unit using wall studs or beams.
• It is recommended to use a plywood board (30 by 24 inches) to mount the
dryer using the walls beams and studs as support, rather than just wood slats.
• Make sure the dryer power cord can reach a 120 Volt outlet.
• Make sure you can connect the exhaust vent to the outside or designated
dryer vent (in a laundry room).
• The length of exhaust ducting should not exceed 6 feet.
• Please read the additional ducting information and warnings in this manual.
"
24.8
Nearest 120 Volt
"
16.73
AC outlet
English
6