Publicidad
Idiomas disponibles
Idiomas disponibles
9 |
MULTILINGUAL
3.2 Configure the sensors in a group
Every sensor can be configured to be added to a single group by setting the jumper
settings; home-group, normal group, single group or 24-hours group.
Bellow you will see an overview of the meaning and how to configure the jumper
settings for that type of group.
Remark : Determine before pairing with the alarm system in which group the sensor
will be operational. Once the sensor is successfully paired with the system, the group
cannot be changed after pairing!
Remark: If the group of a sensor needs to be changed all sensors need to be paired
with the alarm system once again. It is not possible to remove one single sensor from
a group ! (See chapter "Delete all wireless sensors by text message")
Home-group
Normal-group
Single-group
24-hours-group
Remark : It's recommended to install detectors that needs to be operational 24-hours,
for example smoke detectors, in the 24-hours-group.
The default jumper settings for a window/door contact are D0, D1 and D2 (Normal-
group), for the motion detector the default settings are D1 and D2 (Home-group).This
means that the window/door contact will be enabled when the alarm system is in full
security mode or in-home security. The motion detector will only be enabled when the
alarm system is in full security mode. You can enable the full or in-home security by
using the Control panel, remote control, the Eminent e-Alarm APP or your mobile
phone.
Publicidad
