Homeright POWER-FLO PRO 2800 Manual De Instrucciones página 10

IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text
under subheadings therein before set up or use of this product.
Preparing a New Sprayer
Always keep the trigger lock on the spray gun in the locked position while preparing the
system. (Figure F )
• Place the suction tube into a container of soapy water.
• Place the return tube into a metal waste container.
• Turn Pressure Control Knob all the way left (counter-clockwise) to minimize pressure.
(Figure B , page 9)
• Move the Prime/Spray valve down to the Prime position.
• Turn the unit on by moving the On/Off switch to On. (Figure C , page 9)
• Turn Pressure Control Knob to right to start pump.
• Allow the sprayer to run for 15-30 seconds to flush the test fluid out through the return
hose and into the waste container.
• Turn the unit off by moving the On/Off switch to Off. (Figure C , page 9)
• Submerge suction tube in paint. Turn Power Switch ON, and trigger gun into waste pail.
When paint comes out of return tube, turn Prime/Spray valve to SPRAY. When paint comes
out of gun, release trigger. Pump will build up pressure and motor will stop.
• Transfer return tube to paint pail.
• Attach spray tip and guard. Do not over tighten.
• Sprayer is now ready for start up.
Workpiece and Work Area Set Up
• Designate a work area that is clean and well-lit. The work area must not allow access by
children or pets to prevent injury and distraction.
• Route the Power Cord along a safe route to reach the work area without creating a tripping
hazard or exposing the Power Cord to possible damage. The Power Cord must reach the
work area with enough extra length to allow free movement while working.
• There must not be hazardous objects such as utility lines or foreign objects nearby that
will present a hazard while working.
GENERAL OPERATING INSTRUCTIONS
NOTE: Prior to use, add approximately 5 drops of machine oil (Figure G ). Adding this oil is a
daily requirement each time the Spray Gun is used.
Prior to operating the Sprayer, know in advance how to release pressure in the unit's system:
• Engage the Safety Lock on the Spray Gun. (Figure F )
• Turn the Power Switch to its "OFF" position. (Figure C , page 9)
• Turn the Pressure Adjust Knob to it's lowest setting. (Figure B, page 9)
• Unlock the Spray Gun by turning the Safety Lock to the unlocked position. (Figure F )
• Hold the Spray Gun firmly against the side of a grounded container. (Figure H )
• Spray the paint into the container to relieve the system pressure.
• Lock the Spray Gun by turning the Safety Lock to the locked position. (Figure F )
• Turn the Prime/Spray Knob to its "PRIME" position. (Figure D , page 9)
HOW TO USE
800879 POWER-FLO PRO 2800
®
10
F
G
H
Add Oil
ENGLISH