Fast Start Quick Reference Guide - Homeright POWER-FLO PRO 2800 Manual De Instrucciones

FAST START QUICK REFERENCE GUIDE

This is only a quick reference. Read the entire instruction manual prior to using the product.
Setup
1
Remove spray tip and guard from gun.
During first use of Spray Gun, Spray Tip
and Guard will be off of the Spray Gun.
Flushing
1
ba r/M
Pa /p
si
Turn pressure control knob counter-
clockwise to minimum pressure.
Turn Spray/Prime valve to PRIME.
Priming
1
Submerge suction tube in paint. Turn Power Switch ON, and trigger gun into
waste pail. When paint comes out of return tube, turn Prime/Spray valve to
SPRAY. When paint comes out of gun, release trigger. Pump will build up
pressure and motor will stop.
Spraying
1
Put trigger safety lever in locked
position.
NOTE: Always lock the trigger
when not in use, while performing
maintenance or during set-up and
cleaning.
2
b ar /M
P a/ p
si
Connect hose to gun and sprayer.
2
Place Return Tube into waste pail.
Submerge suction tube in water
(water-based materials) or thinner/
cleaner solution (oil-based materials.)
2
2
Spray
Clean
Install tip and guard on gun and hand
tighten. If tip clogs, reverse spray tip
to quickly clear obstructions without
disassembly. (Refer to Page 8 for
assembly instructions)
3
Turn Power Switch OFF. Plug sprayer
into grounded outlet.
3
ba r/M
Pa /p
si
Turn Power Switch ON. Turn Pressure
Control Knob clockwise until pump
starts.
3
Transfer Return Tube to paint pail.
3
ba r/M
Pa /p
si
ba r/M
Pa /p
si
Turn pressure control knob
clockwise to increase pressure
and counter-clockwise to decrease
pressure at the gun.
7
4
Allow fluid to flow out of prime tube
into waste pail for 30-60 seconds.
Turn power switch OFF.
BULLETIN
If sprayer will not prime, remove
suction tube from unit and insert
a screwdriver to release the inlet
valve. Refer to D in the "Sprayer
starts, but does not draw in paint ..."
section in Troubleshooting.
4
Incorrect spray pattern with "tails"
Correct solid spray pattern
Unlock trigger safety lever. Point gun
12" from surface and begin moving
gun before triggering. If tails persist at
highest pressure, switch to smaller tip
or thin material.