YaberAuto YA40 Manual Del Usuario página 9

support@yaberauto.com
Start your Car
1. Insert the plug of the smart clip completely
into the jump starter, All the symbols cycle light
up from left to right; the LCD screen shows the
current voltage of YA40 Jump Starter.
2. Correctly clip the red and black clamps to the
electrodes of the car battery (red to positive and
black to negative)
3. Start the vehicle.
4. When the vehicle is started, remove the jumper
cable from the vehicle battery immediately.
Note: If it does not jump start successfully, please wait 1 minute before
repeating the above steps.
5
EN