Publicidad
Powering on and off the Earbuds
Charging
To power on the earbuds, open the charging case. The earbuds will
power on and the charging case status LED will ash to indicate the
battery level of the charging case. The earbuds can also be powered
on outside of the case by holding the touch sensors for 3 seconds.
To power o the earbuds, return them to the charging case and
close the lid. The earbuds will power o and the charging case status
LED will indicate which earbuds are charging. The earbuds can also
be powered o outside of the case by holding the touch sensors for
8 seconds.
1. Power on the earbuds. The earbuds will automatically attempt to
reconnect to their last Bluetooth® enabled device(s).
2. The earbuds will automatically enter pairing mode anytime they
are not connected to a Bluetooth® device. To enter pairing mode
while connected to a Bluetooth® device, use the device's settings to
disconnect from the earbuds.
3. On your Bluetooth® enabled device, search for and connect to
HyperX Cirro Buds Pro.
4. At this point, an additional Bluetooth® enabled device that had
been paired to the earbuds previously can be reconnected to allow
for multipoint connectivity.
Publicidad
