Agri-Fab 45-0603 Manual De Instrucciones página 5

aSSeMBLy InSTruCTIonS
TooLS reQuIreD For aSSeMBLy
(2) Adjustable Wrench
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches
Lay out and identify the parts and hardware using the
illustrations on page 3 and page 4.
aSSeMBLe THe HITCH MounT aSSeMBLy
STep 1:
(See FIGure 1)
• Insert a slider tube (7) into each end of the hitch
mount assembly (8).
• Attach the slider tube to the hitch mount assembly
using two hex bolts (C), four washers (L), and two
Nylock hex nuts (H). Do not tighten.
C
L
8
L
H
7
7
FIGure 1
STep 2:
(See FIGure 2)
• Attach the hitch mount assembly (8) to the tractor
frame using two U-bolts (6) secured with two mounting
brackets (5), four washers (J), and four hex nuts (E).
Do not tighten.
• If the slider tube does not fully extend into both
U-bolts (6), then loosen the appropriate hex bolt (C)
and reposition the slider tube (7).
• Center the hitch mount assembly on the tractor frame.
• Tighten all hex bolts and hex nuts.
note: Depending on your mower, U-bolts may need to be
installed at an angle.
E
J
5
6
7
5
C
8
FIGure 2