Beurer medical BC 58 Nstrucciones Para El Uso página 16

If the battery change „
measurement is no longer possible and you must replace all
the batteries. Once batteries have been removed from the
device, the time must be reset.
Used batteries do not belong in the household waste. You
are legally obliged to dispose of the batteries. Dispose of
them via your specialist electrical supplier or local collec ting
point for recyclable waste.
note: Batteries containing pollutant sub-
stances are marked as follows: Pb = Battery
contains lead,
Cd = Battery contains cadmium, Hg = Battery
contains mercury.
Setting date and time
You should set the date and time without fail. Otherwise,
you will not be able to save your measured values correctly
with a date and time and to access them again later.
The time is displayed in the 24-hour format.
Tip: If you press and hold the "MEM" button, you can set
the values more quickly.
To set the date and time, proceed as follows:
• Move the touch screen activation switch to the "ON"
position.
• Press the "START/STOP" and "MEM" buttons simultane-
ously. The year display will start to flash. Set the year with
the "MEM" button and confirm with "START/STOP".
" is continuously illuminated,
• Then set the month, day, hour and minutes and confirm
each setting with "START/STOP".
• Pressing the "START/STOP" button again will switch the
display off.
5. Measuring blood pressure
Please ensure the device is at room temperature before
measuring.
Positioning cuff
• Bare your left wrist, making sure that the circulation in the
arm is not restricted by any clothes etc. that are too tight.
Position the cuff on the inside of your wrist.
• Fasten the cuff with the Velcro fastening so that the upper
edge of the monitor is positioned approx. 1 cm below the
ball of your thumb.
• The cuff has to be fitted tightly around the wristbut should
not constrict it.
Important: The instrument should only be operated with the
original cuff.
16