Publicidad
Idiomas disponibles
Idiomas disponibles
Symbols used on the device
Read the safety information and operating instructions before use.
Protect from rain, moisture or a damp environment.
Do not use near flammable or explosive objects.
Always disconnect the device from power if faults occur, during cleaning work or when changing
accessories.
Wear protective gloves when using the device.
Risk of burns due to hot surfaces.
Allow to cool down sufficiently after use.
Declaration of conformity: Products labelled with this symbol fulfil the
applicable directives and standards of the European Economic Area.
The device corresponds to protection class II. (double insulated)
The device must not be disposed of via general household waste.
Additional safety information
•
Ensure that the operating switch is set to position 0 (off) before you plug the power cable into the socket.
•
Attention! The nozzle reaches temperatures of up to 600°C. Always wear protective gloves and
safety glasses. You must not touch the nozzle during operation. Danger of burns!
•
Allow the device to cool completely before putting it away.
•
Never expose the device to rain or moisture. Store the device in a dry place.
•
Do not use the device in a wet environment or in areas with a high level of humidity (bathrooms, sauna,
etc.).
•
Do not leave the device unsupervised. Keep the device away from children.
•
Never direct the air flow towards persons or animals. The device must not be used to dry clothing or hair.
•
Do not use the device around highly flammable and explosive materials and gases.
•
Never prevent the hot flow of air by obstructing the air outlet.
•
Only use original accessories and spare parts from the manufacturer.
•
Do not wear loose clothes or jewellery. Wear anti-slip footwear and use a hairnet if you have long hair.
Ensure a stable position during the work.
•
Check your working area for highly flammable materials before you use the device.
•
Never carry the device by the power cable.
•
If required, only use extension cables with a minimum cross section of 1.5 mm².
•
Repairs (e.g. replacing the power cable) may only be carried out by an electrician.
•
Do not use any chemical removers and solvents at the same time as the hot air gun.
•
Clean the nozzle when it becomes dirty.
•
Ensure that the air inlet and outlet openings are always kept clean and free from dirt.
GB - 12
Publicidad
