Ultenic U10 Manual Del Usuario página 11

Cleaning & Part Replacement
The filters can be bought from the Ultenic official store in Amazon.
It is recommended to clean the dust container immediately after each use. When an excessive
amount of dust are accumulated, and the filter sponge is blocked, it needs to be cleaned
immediately, and can be replaced if necessary. After a long time of use, the roller brush may be
entangled with hair and other long fi bres; it should be cleaned immediately so that the vacuum
cleaner will work more effectively.
Cleaning the dust container and filter system
Rotate the dust container assembly in the
1
direction of the arrow shown in the figure
and take out the dust container. (Fig. 18)
（18）
3
Pour out the dust from the dustcontainer
(Fig. 20)
（20）
5
Remove the fi lter assembly and clean it.
(Fig. 22)
（22）
7
Take out the filter components according to the direction shown in the figure, clean them
(replace them if necessary), and then assemble them in the reverse order.
Hold the dust container with one hand and
2
take out the filter assembly of the dust
container by grasping the metal handle on
the filter assembly with the other hand.
(Fig. 19)
（19）
Take out the filter sponge according to the
4
direction of the arrow in the figure; the
sponge can be cleaned or replaced. (Fig. 21)
（21）
6 Clean or cleaned fi lters should be placed in
a ventilated place to dry before use. (Fig. 23)
（23）