Daikin LMSEY1A09AVM01 Manual De Funcionamiento página 8

4 User interface
Result: The compressor starts up after a pre-set delay
(parameter). This function is useful to protect the compressor
and the relay from power cycling in the event of repeating
power outages. Defrosting (if required) also starts after this
delay.
INFORMATION
In the off status of the unit, the maximum interval between
consecutive defrosts (dl; set in the parameters) is always
updated, in order to maintain the cyclical nature of this
interval. If a defrost interval expires while the unit is off ,
the event is recorded. When the unit is switched on again,
a defrost request is then generated.
4.2.3 To set the temperature
1 Unlock the user interface. See "4.2.1 To unlock the user
interface" [ 4 7].
2 Press the Setpoint/Up arrow button:
3 Use the UP and DOWN buttons to change the temperature
setpoint.
Result: The setpoint has changed.
4.2.4 To shut down
1 Unlock the user interface. See "4.2.1 To unlock the user
interface" [ 4 7].
2 Turn the unit off by pushing the on-off/down arrow button on the
user interface.
Result: The compressor protection times are observed.
Result: Pump down is performed (if enabled).
Result: Defrosting is forcibly terminated and will not resume
when switching on.
Result: The continuous cycle is forcibly terminated and will not
be resumed when switching on.
4.2.5 To navigate between screens
1 Unlock the user interface. See "4.2.1 To unlock the user
interface" [ 4 7].
2 Press the PROGRAM button to enter "dir" mode.
Result: The display shows "dir".
Operation manual
8
3 Use the UP (a) and DOWN (b) buttons to navigate towards the
.
Note: To return to the standard display, go to "ESC" and press the
PROGRAM (c) button.
4.2.6
1 Unlock the user interface. See "4.2.1 To unlock the user
2 Press the PROGRAM button to enter "dir" mode.
desired menu, then press the PROGRAM (c) button to enter the
menu.
a UP button
b DOWN button
c PROGRAM button
CtL Control menu
Pro Display probes menu
HcP HACCP menu
CnF Configuration menu
ALM Alarms menu
PSd Service menu
ESC Exit the menu loop
INFORMATION
If no button is pressed, the terminal will return to the
standard display after 7 seconds.
To change the status of an actuator
INFORMATION
If no button is pressed, the terminal will return to the
standard display after 7 seconds.
interface" [ 4 7].
Result: The display shows "dir". The buttons that are on steady
indicate that the corresponding actuator/function is active. The
buttons that are flashing indicate that the actuator/function is
not active.
a b c
LMSEY1A09/13 + LMSEY2A19/25
Daikin LMS
4P728169-1B – 2023.07