Publicidad
Idiomas disponibles
Idiomas disponibles
gently apply 2 or 3 pumps of #2 Multi–Purpose
Lithium Base Grease. Excessive grease pressure
may damage seals.
Lubricating Gear Case
After every 100 operating hours, grease the gear case
with #2 Multi–Purpose Lithium Base Grease.
1.
Remove bag.
2.
Install grease gun onto fitting thru belt cover
opening (Fig. 27). Gently apply 1–2 pumps of
grease.
3.
Reinstall bag.
Adjusting Blade Brake Cable
Whenever a new blade brake cable assembly is
installed or the blade brake belt is replaced, the blade
brake cable should be adjusted.
1.
Stop engine and wait for all moving parts to
stop. Pull wire off spark plug (Fig. 6).
2.
Loosen cable clamp screw until brake cable
conduit slides (Fig. 28). Pull cable to remove
slack, but do not put tension on spring. Tighten
screw to lock adjustment in place.
All manuals and user guides at all-guides.com
POTENTIAL HAZARD
Do not over–tighten blade brake cable.
Over–tightening could cause blade brake to
be pulled off brake drum. If brake does not
contact drum, blade will not stop rotating
when control bar is released.
WHAT CAN HAPPEN
A rotating blade could cause serious
personal injury.
HOW TO AVOID THE HAZARD
Check the blade brake mechanism each
time brake cable is adjusted to ensure
brake is stopping blade in 3 seconds or less.
If blade does not stop rotating in 3 seconds
or less, bring unit to your local Authorized
Toro Service Dealer for inspection and
repair.
Cleaning Mower
Plug
To ensure best performance, the discharge tunnel plug
must be cleaned after each use. When grass is thick
and lush, clippings may collect on and around the
plug; this may make plug removal difficult. After
each use, remove plug from discharge tunnel and
clean off all debris.
Discharge Tunnel
Always be sure that discharge tunnel door closes
securely when handle is released. If debris prevents
discharge door from closing securely, clean inside of
discharge tunnel and door thoroughly.
EN–14
Publicidad
