TTI TCB-5289 Manual De Usuario página 5

EN
Note: ASQ will automatically turn off if the TSQ function turned on
b. BEP: Press FUN, the LCD display "FUNC", when "FUNC" disappear, press ASQ, the LCD displays "BP", the
key beep function is on, press it again to turn off BEP function.
5. TSQ key
a. TSQ: CTCSS and DCS code
Press TSQ, The LCD will display "CTC or DCS", the CTCSS or DCS function is on; press it again to turn off
the function.
Note1: This function is available only when you installed optional CTC board.
Note2: when you choose RXC or TXC off, this function is not valid.
Note3: When the CTCSS or DCS is on, the speaker will boot only when it receive corresponding CTCSS or
DCS code.
Note4: When the CTCSS or DCS is on, the RB function will turn off.
b. TOT (Timer Out Timer)
Press FUN, the LCD displays "FUNC", when "FUNC" disappear, press TSQ, the LCD displays "XXX S", you
can adjust the TX limit time by the channel knob, press any other key to exit, or wait for 5 seconds , the radio
will store the setup and exit.
When the continuous TX time is over the TOT limit, the radio will stop TX.
TOT Optional: 15-600 seconds, step 15seconds, default: 180 seconds
6. SC key
SC (Scan function)
Apasati SC, ecranul afiseaza "SC" si clipeste, statia porneste functia de scanare, rotiti butonul de canale
pentru a selecta modul de scanare, apasati orice tasta pentru a iesi din functia de scanare.
Note: the scan only on pre-stored channels in present BAND or MEM.
SKP (Scan Skip function)
Press FUNC, the LCD display "FUNC", when "FUNC" disappear, press SC, the present channel will delete
from the scan list. The scan will skip this channel. Press the key again to add present channel to scan list..
7. A/F key
A/F (AM/FM)
Press it to switch between AM and FM mode, the LCD will display AM or FM.
HI (High / Low power function)
Press FUN, the LCD display "FUNC", when "FUNC" disappear, press A/F. The LCD displays "XXX", then turn
the channel knob to choose the TX power, press any other key to exit.
8. MEM key
MEM (Memory channel)
Press MEM key, the radio will work in channel store mode, you can add 8 channels to it.
You can store any channel inside any band, for example, if you want to store the E band channel 9 to MEM
2, the steps are:
A. Change to E band 9CH, then hold and press MEM for over 2 seconds, the LCD will display "MEM" and
flashes.
B. Turn channel knob to choose MEM2.
C. Hold and press MEM for over 2 seconds to confirm the setup and exit. The storage is done.
NB (Noise blanker)
Press FUN, the LCD display "FUNC", when "FUNC" disappear, press
MEM, the LCD displays "NB", the NB/ANL function is turned on, press
the MEM key again to turn this function off.
9. DW key
DW (Dual Watch)
Turn channel knob to choose first channel, then press DW, the LCD display "DW' and flashes, then turn
channel knob again to choose second channel, then press DW key to enter Dual watch function. Press any
5