TTI TCB-5289 Manual De Usuario página 6

key to exit dual watch.
RB (Roger beep)
Press FUN, the LCD display "FUNC", when "FUNC" disappear, press DW, the LCD displays "RB XXX", turn the
channel knob to choose the RB sound you need. Press any other key to exit. When any RB sound be choose,
the LCD will displays "RB"
Note: RB sound can be programmed by software, 8 groups in total
10. PRG key
PRG (Programming)
Press PRG key to enter channel data menu. You can change the channel data by turning the channel knob,
the programming is for single channel. Press EXT to exit this function.
For example if you want to change the DCSSN754 code into E BAND 9CH, following:
A. Turn the channel to E BAND 9CH.
B. Press PRG
C. Turn channel knob to choose TXC menu.
D. Press PRG key, the LCD display CTC or DCSN or DCSI or OFF, turn channel knob to choose DCSN
E. Press PRG to show the group number of DCSN, turn channel knob to choose 754N
F. Press PRG key to exit and store the DCS number.
G. Press EXT key to exit channel data edit.
The menus available in the PRG:
A. RXC the signaling for RX: CTC, DCSN , DCSI, OFF
B. TXC the signaling for TX : CTC, DCSN, DCSI, OFF
SET (Function menu setup)
For example to turn off Beep sound.
A. Press FUN, the LCD display "FUNC", when "FUNC" disappear, press PRG, then turn channel knob to
choose BEP menu.
B. Press PRG again, then turn channel knob to choose off.
C. Press PRG to exit BEP setup.
D. Press EXT to exit SET.
The functions menu in the set SET function:
TOT : Time out timer
SCN : Scan mode,optional TI. SQ Default mode: SQ
• SQ: When scanning find a signal, the scan will not stop when the signal existing. if the signal last for 30
seconds, the scan will stop for 30 seconds, then stop for 5 seconds(Depend the Scan recovery time you
set), if no operation during the 35 seconds, the scan will start again.
• TI: When scanning find a signal, the scan stops for 5 seconds(Depend the Scan recovery time you set),
if nooperation during this 5 seconds, the scan will start again.
SCT : Scan recovery time optional: 5S. 10S. 15S Default: 5S
BEP : key sound optional: ON. OFF, Default: ON
PD : channel data edit mode, Optional: ON. OFF Default: OFF
• OFF: When enter channel date edit (PRG function), the changes is only for present channel.
• ON: When enter channel date edit (PRG function), the changes is
for all the channel.
STEP : In VFO mode,turn the channel knob to choose the step size,
Optional: 5K. 10K. 100K. 1M Default: 5K
Note1:The function menu setup can be done also by FUN key+ function buttons, they are same.
11. EXT key
EXT: Press this key to exit channel data setup and function menu setup.
LOCK (channel lock function)
Press FUN, the LCD display "FUNC", when "FUNC" disappear, press EXT, the LCD displays "LOCK" then
disappear, all the keys except FUNC,CH9,CH19 is valid, the rest keys are locked. Press FUNC+EXT again,
LCD displays UNLOCK then disappear, the LOCK function is off.
6